HighPoint NVMe G5 Data RAID Installation Guide (Linux)
8
4. Using the system terminal with root privileges, browse to the directory where the driver download is
located, and enter the following commands to extract the Linux Open-source Driver software package:
tar zxvf HighPoint_NVMe_G5_Linux_Src_vx.x.xx_xx_xx_xx.tar.gz
Note: The driver revision shown in the screenshots may not correspond with current software releases.
Please make sure to download the latest driver updates from the product’s Software Updates page.
5. Install the open-source Driver using the following command.
sh hptnvme_g5_linux_src_vx.x.xx_xx_xx_xx.bin or
./hptnvme_g5_linux_src_vx.x.xx_xx_xx_xx.bin
6. After driver installation is complete, the system will prompt you to restart to make the driver take effect.
Manually restart the system.
7. After the distribution has rebooted, open the system terminal with root privileges and check the driver
status using the following command:
dmesg | grep hptnvme
To Next Page
Loading...
