Multi-Spectrum Binocular User Manual
21
3.8
Set Display Mode
You can select different display modes in different scenes. Hold in
live view interface to switch display modes in the optical channel. Day,
night, and auto modes are selectable.
: Day Mode: You can use this mode at daytime and in bright
environment. In day mode, the IR light is off automatically.
: Night Mode: You can use this mode at nights. In night mode, the IR
light is on automatically.
: Auto Mode: The day mode and night mode switch automatically
according to the ambient brightness.
Figure 3-4 Day/Night Mode
3.9
Set Picture in Picture Mode
Hold in live view to enable PIP, and hold again to exit PIP. The
image center is displayed in upper middle of the interface.
To Next Page
Loading...