HIKOKI DV 18DBSL - Additional Safety Warnings; Cordless Driver Drill; Impact Driver Drill Safety Warnings

English
26
6) Service
a) Have your power tool serviced by a qualifi ed repair person using only identical
replacement parts.
This will ensure that the safety of the power tool is maintained.
CAUTION
Keep children and infi rm persons away.
When not in use, tools should be stored out of reach of children and infi rm persons.
CORDLESS DRIVER DRILL / IMPACT DRIVER DRILL
SAFETY WARNINGS
<DV18DBSL>
1. Wear ear protectors when impact drilling.
Exposure to noise can cause hearing loss.
<DS14DBSL / DS18DBSL / DV18DBSL>
1. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
2. Hold power tool by insulated gripping surfaces, when performing an operation
where the cutting accessory or fastener may contact hidden wiring.
Cutting accessory or fasteners contacting a “live” wire may make exposed metal parts of
the power tool “live” and could give the operator an electric shock.
ADDITIONAL SAFETY WARNINGS
1. Make sure that the area to be drilled is absolutely free of any hidden obstructions
including electrical wiring, water, or gas pipes. Drilling into the aforementioned
may result in electric shock or short circuit, gas leak or other hazards that can
cause serious accidents or injuries.
2. Secure the workpiece. A workpiece clamped with clamping devices or in a vice is
held more secure than by hand.
3. Setting up and checking the work environment. Check if the work environment is
suitable by following the precaution.
4. Do not allow foreign matter to enter the hole for connecting the battery.
5. Never disassemble the battery and charger.
6. Never short-circuit the battery. Shortcircuiting the battery will cause a great electric
current and overheat. It results in burn or damage to the battery.
7. Do not dispose of the battery in fi re. If the battery is burnt, it may explode.
8. Bring the battery to the shop from which it was purchased as soon as the post-
charging battery life becomes too short for practical use. Do not dispose of the
exhausted battery.
9. Do not insert object into the air ventilation slots of the charger. Inserting metal
objects or infl ammables into the charger air ventilation slots will result in electrical
shock hazard or damaged charger.
10. When mounting a bit into the keyless chuck, tighten the sleeve adequately. If the
sleeve is not tight, the bit may slip or fall out, causing injury.
000BookDS14DBSLChS.indb26000BookDS14DBSLChS.indb26 2017/12/088:45:022017/12/088:45:02