1). Loosen the adjusting nut.
2). Adjust the pan direction [0° to 360°].
3). Adjust the tilt direction [0° to 90°].
4). Rotate the camera [0° to 360°] to adjust the lens to the desired
viewing angle.
5). Tighten the adjusting nut to complete the installation.
Waterproof Measures
If the camera is installed outdoor, you should use the waterproof
accessory or tapes to waterproof the cables. Otherwise the cables
might get wet or a short circuit occurs.
2.3.1 Install Network Cable Waterproof Jacket
To Next Page
Loading...
