Network Cube Camera·Quick Start Guide
18
Press RESET about 10 s when the camera is power on or
rebooting to restore the default settings, including the user
name, password, IP address, port No., etc.
Only certain models support WPS function.
A wireless router with the WPS function is required to enable
the WPS function of the camera. Refer the steps below.
Steps:
Press the WPS button on the router.
Press the WPS button (about 2 s) on the camera within 120 s
you enable the WPS of the router to join in the wireless
network.
Note:
The WPS button works as a reset button only when you
press it when the camera is powering on.
Press the WPS button on the camera, and then press the
WPS button on the router will work as well, and the expire
time of WPS connection on the camera is 120 s.
The link indicator blinks if the wireless connection
succeeded.
To Next Page
Loading...
Need help?
General
