Need help?Do you have a question about the HIKVISION DS-2CD2512F-I and is the answer not in the manual?
Details FCC compliance, including testing and potential interference issues.
Outlines the two specific conditions required for FCC compliance.
States compliance with European Union directives and CE marking.
Step-by-step instructions for securely mounting the camera on a ceiling.
Procedure for installing the camera on a ceiling using a gang box.
Instructions for attaching the camera to a ceiling using an optional bracket.
Detailed steps for mounting the camera onto a wall with a bracket.
How to insert and remove the micro SD card for local storage.
Instructions for modifying network parameters like IP address and port via software.
General| Image Sensor | 1/3" Progressive Scan CMOS |
|---|---|
| Minimum Illumination | 0.01 Lux @(F1.2, AGC ON), 0 Lux with IR |
| IR Range | Up to 30m |
| Wide Dynamic Range | Digital WDR |
| Digital Noise Reduction | 3D DNR |
| Video Compression | H.264/MJPEG |
| Bit Rate | 32 Kbps ~ 8 Mbps |
| Ingress Protection | IP66 |
| Camera Type | Dome |
| Lens | 2.8 mm (fixed) |
| Day & Night | IR cut filter with auto switch |
| Max. Image Resolution | 1280 x 960 |
| Frame Rate | 30 fps @ 1280 × 960 |
| Image Settings | Brightness, Contrast, Saturation, Sharpness, White Balance, Gain, Backlight Compensation |
| Network Storage | NAS |
| Protocols | TCP/IP, HTTP, DHCP, DNS, DDNS, RTP, RTSP, PPPoE, SMTP, NTP, SNMP, HTTPS, FTP, 802.1x, QoS |
| Security | User authentication |
| Network Interface | RJ45 10/100 Base-T |
| Operating Conditions | -30 °C ~ 60 °C (-22 °F ~ 140 °F), Humidity 95% or less (non-condensing) |
| Power Supply | PoE (802.3af) |
To Next Page