Network Camera User Manual
130
Region Exiting Detection
2. Check Enable checkbox to enable the function.
3. Select the Region from the drop-down list for detection settings.
4. Set the Max. Size and Min. Size for valid targets. Targets smaller or larger than the
valid target size are not able to trigger detection.
Max. Size: The maximum size of a valid target. Targets with larger sizes would not
trigger detection.
Min. Size: The minimum size of a valid target. Targets with smaller sizes would
not trigger detection.
5. Set the detection area. Click on the live video to specify the four vertexes of the
detection region.
6. Select the detection target. Human and vehicle are available. If the detection
target is not selected, all the detected targets will be reported, including the
human and vehicle.
7. Drag the slider to set the sensitivity value.
Sensitivity: Range [1-100]. Sensitivity stands for the percentage of the body part
of an acceptable target that exits the pre-defined region.
Sensitivity = 100 – S
1
/S
T
*100
S
1
stands for the target body part that exits the pre-defined region. S
T
stands for
the complete target body.
To Next Page
Loading...
Need help?
General
