HIKVISION DS-2CD7253F-EIZ

Quick Operation Guide of Network Camera
6
2
Back focus ring
3
SD card slot
4
Auto-iris interface
5
10M/100M self-adaptive Ethernet interface
6
VIDEO OUT: Video output interface
7
AUDIO OUT: Audio output interface
8
POWER: Power LED indicator
9
Power supply interface
10
MIC IN: Audio input interface
11
D+, D-: RS-485 interface
12
IN, G: Alarm input interface
13
1A, 1B: Alarm output interface
14
Ground
15
RESET: Reset button
Notes:
 After the powering on of the camera, pressing and holding the RESET button for about 10
seconds can reset all the parameters to the default settings.
 The type of auto-iris interface is shown in Figure 1-10, and the definition of each pin is shown
below:
Figure 1-10 Auto-iris Interface
Table 1-6 Pins
DC-driven
1
Damp-
2
Damp+
3
Drive+
4
Drive-
Damp+, Damp-, Drive+ and Drive- pins are used when the auto-iris is driven by DC.
Camera wiring Diagram: