3. Take apart the junction box, and align the screw
holes of the camera with those on the Junction
box’s cover.
4. Attach the camera to the junction box’s cover with
supplied screws.
Figure 2-6 Attach the Camera to the Junction Box’s
Cover
5. Attach the junction box’s body to the ceiling/wall by
aligning the screw holes of the junction box.
6. Secure the junction box’s body on the ceiling/wall
with supplied screws.
Figure 2-7 Secure the Junction Box’s Body to the
Wall/Ceiling
7. Route the cables through cable holes, or side
openings.
8. Combine the junction box’s cover with its body.
Figure 2-8 Combine the Junction Box’s Cover with its
Body
9. Repeat the step 5 and 6 of 2.1.1 Ceiling/Wall
Mounting to finish the installation.
To Next Page
Loading...
Need help?
General
