UM DS-2CE17H0T-IT3F 052220NA 4
Warnings
In the use of the device, you must be in strict
compliance with the electrical safety regulations
of the nation and region.
Input voltage should meet both the SELV (Safety
Extra Low Voltage) and the Limited Power Source
with 12 VDC according to the IEC60950-1
standard and IEC62368-1 standard. Refer to
technical specifications for detailed information.
Do not connect multiple devices to one power
adapter to avoid overheating or a fire hazard
caused by overload.
Make sure that the plug is firmly connected to
the power socket.
Make sure that the device is firmly fixed if wall
mounting or ceiling mounting is adopted.
If smoke, odor, or noise rise from the device, turn
off the power at once, unplug the power cord,
and then contact the service center.
Unprofessional personnel should never attempt
to disassemble the camera.
Cautions
Do not drop camera or subject it to physical
shock.
Do not touch sensor modules with fingers.
Do not place the camera in extremely hot, cold
(the operating temperature shall be -40° to 60°
C), dusty, or damp locations, and do not expose it
to high electromagnetic radiation.
If cleaning is necessary, use a clean cloth with a
bit of ethanol, and wipe it gently.
Do not aim the camera at the sun or extra bright
places.
The sensor may be burned out by a laser beam,
so if any laser equipment is in use, make sure
that the surface of the sensor will not be
exposed to the laser beam.
To avoid heat accumulation, good ventilation is
required for the operating environment.
Keep the camera away from liquid while in use for
non-waterproof device.
While in delivery, pack the camera in its original
packing or packing of the same material.
To Next Page
Loading...
Need help?
General
