© Hikvision
Security Audit Log
Purpose:
The Security Audit Log refers to the security operation logs. You can search and analyze the
security log files of the camera so that to find out the illegal intrusion and troubleshooting the
security events.
Security audit logs can be saved on device flash. The log will be saved every half hour after device
booting.
Due to limited saving space of the flash, you can also save the logs on a log server. Configure the
server settings at Advanced Settings.
Searching Logs
Steps:
1. Enter the Security Audit Log interface:
Configuration > System > Maintenance > Security Audit Log
2. Set the log search conditions to specify the search, including the Major Type, Minor Type,
Start Time and End Time.
Figure 6-53 Log Query Interface
3. Click Search to search log files. The matched log files will be displayed on the Log list
interface.
4. To export the log files, click Export to save the log files in your computer.
Setting Log Server
Steps:
1. Check Enable Log Upload Server.
2. Input Log Server IP and Log Server Port.
3. Click Test to test settings.
4. Install certificates. Client certificate and CA certificate are required.
Client Certificate
(1) Click Create button to create the certificate request. Fill in the required
To Next Page
Loading...
Need help?
General
