HIKVISION DS-2DE3304W-DE - Configuring PTZ Limit Stops

User Manual of Network Mini PTZ Camera
© Hikvision
42
application scene of the speed dome is complicated.
 PTZ OSD: Set the on-screen display duration of the PTZ status.
 Zoom Status: Set the OSD duration of zooming status as 2 seconds, 5 seconds,
10 seconds, Always Close or Always Open.
 PT Status: Set the azimuth angle display duration while panning and tilting as
2 seconds, 5 seconds, 10 seconds, Always Close or Always Open.
 Preset Status: Set the preset name display duration while calling the preset as
2 seconds, 5 seconds, 10 seconds, Always Close or Always Open.
 Power-off Memory: The PTZ camera can resume its previous PTZ status or
actions after it restarted from a power-off. You can set the time point of which
the PTZ camera resumes its PTZ status. You can set it to resume the status of 30
seconds, 60 seconds, 300 seconds or 600 seconds before power-off.
3. Click to save the settings.
6.3 Configuring PTZ Limit Stops
Purpose:
The camera can be programmed to move within the configurable limit stops
(left/right, up/down).
Steps:
1. Enter the Limit Configuration interface:
Configuration > Advanced Configuration > PTZ > Limit
Figure 6-3 Configure the PTZ Limit
2. Click the checkbox of Enable Limit and the limit type can be only set as Manual