HIKVISION DS-7108NI-Q1/8P/M

Figure 5-6 IP Camera Management Interface
2. Select a desired network camera.
3. Click
to add the camera.
Note
If the camera is inacve, the device will acvate it automacally with the password you have set
during device acvaon.
Add Network Camera Manually
Before You Start
• Ensure your network camera is on the same network segment with your video recorder.
• Ensure the network
connecon is valid and correct.
• Ensure the network camera is
acvated.
Steps
1. Go to
Conguraon → Camera → IP Camera .
2. Click in Added Device List.
3. Set network camera parameters, including IP address, protocol, management port, etc. You can
check Use Camera
Acvaon Password to use the device password to add network camera(s).
4.
Oponal: Click Add More to add another network camera.
5. Click OK.
Network Video Recorder User Manual
23