35
Figure 10. HDD Management Menu
4. Click the Property button. This will take you to the Property Settings menu.
5. Set HDD Status to Redundancy, shown in Figure 11. Verify at least one other HDD is set to R/W.
(read/write).
6. Click the OK button to save settings and return to the previous menu.
Figure 11. HDD Property Settings
7. Navigate to the Record Settings menu by clicking Menu > Settings > Record Setting.
8. Click on the General tab.
9. Select the Camera to be used for redundancy.
10. Next to More Settings, click on the Set button. This will bring up additional settings for the selected
camera (shown in Figure 12).
To Next Page
Loading...
