Need help?Do you have a question about the HIKVISION DS-7604NI-Q1 and is the answer not in the manual?
General| Audio system | 2-way |
|---|---|
| Input bandwidth | 40 Mbit/s |
| Number of users | 16 user(s) |
| Output bandwidth | 80 Mbit/s |
| Maximum resolution | 3840 x 2160 pixels |
| Video input channels | 4 channels |
| Supported resolutions | 3840 x 2160, 1920 x 1080, 1600 x 1200, 1280 x 1024, 1280 x 720, 1024 x 768 |
| Audio formats supported | G.711 A-law, G.711 μ-law, G.726 |
| Video formats supported | H.264, H.264+, H.265, H.265+ |
| Wi-Fi | No |
| HDD capacity | - GB |
| HDD interface | SATA |
| Maximum storage capacity | 8 TB |
| Number of HDDs installed | 0 |
| Number of HDDs supported | 1 |
| Networking standards | IEEE 802.3af, IEEE 802.3at |
| USB 2.0 ports quantity | 2 |
| Ethernet LAN data rates | 10, 100 Mbit/s |
| Power over Ethernet (PoE) | Yes |
| Supported network protocols | TCP/IP, DHCP, IPv4, IPv6, DNS, DDNS, NTP, RTSP, SADP, SMTP, SNMP, NFS, iSCSI, ISUP, UPnP, HTTP, HTTPS |
| Power over Ethernet (PoE) ports quantity | 4 |
| Power consumption (typical) | 10 W |
| Total Power over Ethernet (PoE) budget | 50 W |
| Operating temperature (T-T) | -10 - 55 °C |
| Operating relative humidity (H-H) | 10 - 90 % |
| Certification | Part 15 Subpart B, ANSI C63.4-2014 |
Weight and Dimensions| Depth | 240 mm |
|---|---|
| Width | 320 mm |
| Height | 48 mm |
| Weight | 1000 g |
Details FCC compliance and conditions for the device's operation.
Specifies the two conditions under which the device must operate.
States product compliance with EU directives and disposal information.
Confirms compliance with Canadian ICES standards.
Describes the front panel components and indicators for various NVR models.
Details the rear panel interfaces and connectors for different NVR series.
Provides guidelines for installing the NVR, including rack mounting and cable routing.
Details the steps for installing a hard disk drive (HDD) into the NVR.
Estimates storage space usage based on recording bit rate per hour.
Illustrates the hierarchical structure of the NVR's menu options.
Explains the proper procedures for starting up and shutting down the NVR.
Guides through the initial activation process by setting an admin password.
Describes how to configure and use a pattern for device login.
Explains the process of logging into the device using user credentials.
Details how to use the setup wizard for initial device configuration.
Explains how to configure the NVR's network settings for remote access.
Guides on how to add network cameras to the NVR for live view and recording.
Describes how to view live video feeds from connected cameras and understand status icons.
Explains how to configure recording modes like continuous or motion detection.
Details how to play back recorded video files using various modes and controls.
Instructions for logging into the NVR via a web browser after activation.
Guides on installing necessary browser plug-ins for full functionality.
To Next Page