Quick Operation Guide of DS-9600/8600/7600NI-ST Series NVR
19
Using the Start Wizard
By default, the Start Wizard will start once the NVR has loaded.
Operate the Start Wizard by following the steps described below:
Steps:
1. The Setup Wizard will walk you through some important settings of your NVR. If you don’t want to use the
Setup Wizard at this time, click the Cancel button. You can also choose to use the Setup Wizard next time
by leaving the “Start Wizard when NVR starts?” checkbox checked.
2. Click Next button on the Wizard window to enter the Login window.
3. Enter the admin password. By default, the password is 12345.
4. To change the admin password, check the New Admin Password checkbox. Enter the new password and
confirm the password in the given fields.
5. Click the Next button to enter the date/time settings window.
6. After the time settings, click Next button which to go back to the Network Setup Wizard window.
To Next Page
Loading...
Need help?
General