HIKVISION DS-8616NXI-K8 User Manual

Network Video Recorder User Manual
184
14.9 Restore Default Settings
Steps
1. Go to Maintenance → Default.
Figure 14-19 Restore Default Settings
2. Select the restore type from the following three options.
Restore Defaults
Restore all parameters, except the network (including IP address, subnet mask, gateway,
MTU, NIC working mode, default route, server port, etc.) and user account parameters, to the
factory default settings.
Factory Defaults
Restore all parameters to the factory default settings.
Restore to Inactive
Restore the recorder to inactive status.
Note
The recorder will reboot automatically after restoring to the default settings.
14.10 Schedule Reboot
The device will automatically restart according to the schedule.
Steps
1. Go to Maintenance → System Service → System Service → Schedule Reboot.
2. Check Enable.
3. Set the reboot schedule.
4. Click Apply.

HIKVISION DS-8616NXI-K8 Specifications

General

Model	DS-8616NXI-K8
Category	Network Hardware
Video Input	16 Channels
Video Compression	H.265+/H.265/H.264+/H.264
Audio Input	16 Channels
Audio Output	1 Channel
Two-Way Audio	Yes
Synchronous Playback	16-ch
Outgoing Bandwidth	160 Mbps
HDD Bays	8
SATA	8 SATA interfaces
Alarm In/Out	16 In/4 Out
Operating Humidity	10% to 90%
IP Video Input	16 Channels
Video Output	HDMI, VGA
Decoding Format	H.265/H.264
Decoding Capability	16 Channels
Network Interface	2 RJ-45 10/100/1000 Mbps self-adaptive Ethernet interfaces
USB Interface	2 x USB 2.0, 1 x USB 3.0
Power Supply	100 to 240 VAC, 50 to 60 Hz
Operating Temperature	-10°C to +55°C (14°F to 131°F)