Need help?Do you have a question about the HIKVISION DS-7608NI-Q1/8P and is the answer not in the manual?
General| Two-way talk | Yes |
|---|---|
| Input bandwidth | 80 Mbit/s |
| Number of users | 64 user(s) |
| Maximum resolution | 4096 x 2160 pixels |
| Video input channels | 8 channels |
| Supported resolutions | 4096 x 2160, 3840 x 2160, 2560 x 1440, 1920 x 1080, 1600 x 1200, 1280 x 1024, 1280 x 720 |
| Audio formats supported | G.711 A-law, G.711 μ-law, G.726 |
| Video formats supported | H.264, H.264+, H.265, H.265+, MPEG4 |
| Certification | FCC Part 15 Subpart B, ANSI C63.4-2014 CE EN 55032: 2015, EN 61000-3-2, EN 61000-3-3, EN 50130-4, EN 55035: 2017 |
| Product color | Black |
| Rack capacity | 1U |
| Audio RCA outputs | 1 |
| Networking standards | IEEE 802.3af, IEEE 802.3at |
| USB 2.0 ports quantity | 2 |
| Ethernet LAN data rates | 10, 100 Mbit/s |
| Supported network protocols | TCP/IP, DHCP, IPv4, IPv6, DNS, DDNS, NTP, RTSP, SADP, SMTP, SNMP, NFS, iSCSI, ISUP, UPnP, HTTP, HTTPS |
| Power over Ethernet (PoE) ports quantity | 8 |
| Wi-Fi | No |
| HDD capacity | - GB |
| HDD interface | SATA |
| Maximum storage capacity | 8 TB |
| Number of HDDs installed | 0 |
| Operating temperature (T-T) | -10 - 55 °C |
| Operating relative humidity (H-H) | 10 - 90 % |
| Power consumption (typical) | 10 W |
| Total Power over Ethernet (PoE) budget | 75 W |
Weight and Dimensions| Depth | 240 mm |
|---|---|
| Width | 320 mm |
| Height | 48 mm |
| Weight | 1000 g |
Procedures for starting, shutting down, and activating the NVR for first-time use.
Step-by-step guide for configuring basic NVR settings using the setup wizard.
Instructions on how to activate and add network cameras to the NVR.
Setting up essential parameters for controlling PTZ cameras.
Configuring camera presets, patrol paths, and movement patterns.
Setting stream type, resolution, encoding, and other recording parameters.
Configuring schedules for continuous, motion, alarm, or VCA triggered recording.
Setting up motion detection zones, sensitivity, and trigger actions.
Setting up recording triggered by Video Content Analysis events.
Various methods for playing back recorded video files.
Procedures for exporting and backing up recorded video files.
Configuring motion detection zones, sensitivity, and alarm response actions.
Defining system actions triggered by alarms or exceptions.
Setting up face detection rules, sensitivity, and alarm linkage.
Configuring virtual lines for detecting objects crossing specific paths.
Setting up virtual regions for detecting unauthorized entry or loitering.
Searching for captured face images and playing related video files.
Searching for specific behaviors detected by VCA and playing related video.
Configuring basic network parameters like IP address, gateway, and DNS.
Step-by-step guide for initializing newly installed hard disk drives.
Updating the NVR firmware using local backup or FTP server.
Solutions for common problems encountered during NVR operation.
To Next Page
