Need help?Do you have a question about the HIKVISION DS-7608NI-E1 and is the answer not in the manual?
General| Maximum frame rate | 60 fps |
|---|---|
| Maximum resolution | 1920 x 1080 pixels |
| Alarm input channels | 4 |
| Video input channels | 16 channels |
| HDMI output | Yes |
| Audio RCA inputs | 1 |
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| Ethernet LAN data rates | 10, 100, 1000 Mbit/s |
| Supported network protocols | TCP/IP, DHCP, Hik-Connect, DNS, DDNS, NTP, SADP, SMTP, NFS, iSCSI, UPnP, HTTPS |
| Supported graphics resolutions | 1024 × 768, 1280 × 1024, 1920 × 1080 |
| HDD capacity | 0 GB |
| HDD interface | Serial ATA |
| Maximum storage capacity | 4 TB |
| Number of HDDs installed | 0 |
| Output voltage | 12 V |
| Power consumption (typical) | 10 W |
| Operating temperature (T-T) | -10 - 55 °C |
| Operating relative humidity (H-H) | 10 - 90 % |
| Product color | Black |
| Rack capacity | 1U |
Weight and Dimensions| Depth | 240 mm |
|---|---|
| Width | 315 mm |
| Height | 48 mm |
| Weight | 1000 g |
Provides step-by-step instructions for powering the NVR on and off properly.
Explains how to set a strong administrator password for initial device activation.
Guides through the initial setup wizard for basic NVR configuration.
Details the process of activating and adding IP cameras to the NVR.
Details how to set PTZ parameters before controlling PTZ cameras.
Defines parameters affecting image quality, stream type, and resolution.
Sets the recording schedule for cameras, enabling automatic start/stop.
Configures motion detection parameters and schedules recording upon event detection.
Sets up recording to be triggered by alarm inputs.
Configures recording triggered by various VCA events like face detection.
Enables saving recordings to both R/W and redundant HDDs for data safety.
Covers various methods for playing back recorded video files.
Covers methods for backing up recorded video files to external devices.
Configures motion detection alarms, including area, sensitivity, and response actions.
Details how to set handling actions for external sensor alarms.
Configures alarms and response actions for video loss detection.
Sets up alarms and response actions for video tampering detection.
Configures handling actions for various system exceptions like HDD errors.
Defines actions taken when an alarm or exception occurs, like hints or alerts.
Configures face detection settings, including rules and sensitivity.
Sets up vehicle detection for traffic monitoring, including lane and rule configurations.
Configures line crossing detection rules, direction, and sensitivity.
Sets intrusion detection rules for virtual regions, including threshold and sensitivity.
Configures region entrance detection rules and sensitivity.
Configures region exiting detection, referencing entrance detection steps.
Sets loitering detection rules, referencing intrusion detection steps.
Configures people gathering detection, referencing intrusion detection steps.
Sets fast moving detection rules, referencing intrusion detection steps.
Configures parking detection rules, referencing intrusion detection steps.
Sets unattended baggage detection, referencing intrusion detection steps.
Configures basic network settings like IP address, gateway, and DNS.
Explains how to initialize newly installed HDDs before use.
Offers solutions for common issues like no image, audible warnings, and camera connection problems.
To Next Page