If User Has Changed the NVR Device ID#:
1. Press DEV button.
2. Press Number buttons to enter user-defined Device
ID#.
3. Press Enter button.
4. Press Power button to start device.
To Turn NVR Off:
If User Is Logged On:
1. Hold Power On/Off button (1) down for five seconds
to display the “Yes/No” verification prompt.
2. Use Up/Down Arrow buttons (12) to highlight
desired selection.
3. Press Enter button (12) to accept selection.
If User Is Not Logged On:
1. Hold Power On/Off button (1) down for five seconds
to display the user name/password prompt.
2. Press the Enter button (12) to display the on-screen
keyboard.
3. Input the user name.
4. Press the Enter button (12) to accept input and
dismiss the on-screen keyboard.
5. Use the Down Arrow button (12) to move to the
“Password” field.
6. Input password (use on-screen keyboard or numeric
buttons (3) for numbers).
7. Press the Enter button (12) to accept input and
dismiss the on-screen keyboard.
8. Press the OK button on the screen to accept input
and display the Yes/No” verification prompt (use
Up/Down Arrow buttons (12) to move between
fields)
9. Press Enter button (12) to accept selection.
User name/password prompt depends on NVR is
configuration. See "System Configuration" section.
Enable IR Remote: Press DEV button, enter NVR Device
ID# with number keys, press Enter to pair unit with the
NVR.
To Next Page
Loading...
Need help?
General
