Video Wall Controller • User Manual
23
Select a signal source window to move directly.
Select a signal source window, and enter the specific X and Y values in the pop-up window.
Adjust Position of a Signal Source Window
Divide a signal source window: Select a signal source window, and click the window division
icon.
Adjust the size of a signal source window:
Drag the edge of a signal source window to adjust its size.
Select a signal source window and enter W and H values in the pop-up window.
Click at the upper right corner of the signal source window to make it fully cover the
occupied output ports and click to restore the original size.
Zoom In the Window
Select a signal source window, and click to set the signal source window to the bottom.
Select a network signal source to start decoding or stop decoding, and set decoding delay.
To Next Page
Loading...
Need help?
General
