HIKVISION DS-D5043QE - Control Button and Joint

12
User's Manual
3.1 Control button and joint
Signal wire
• Connect the VGA wire: Connect the 15 -pin VGA signal wire to the back
of the display and the VGA port of the computer or other devices.
• Connect the HDMI wire: Connect the 19 -pin HDMI signal wire to the
back of the display and the HDMI port of the computer or other devices.
• Connect power cord: Connect the power cord to the AC jack on the back
of the display.
1
2
3
4
RS232
HDMI
D-SUB
1.
Audio in
2. D-SUB
3.
HDMI signal input
4. RS232 (Serial port communication control)
When RS232 port is connected for control, please use the adapter specied
below and normal network cable to connect the 9-pin RS232 cable to the
PC port and the network cable to the RS232 terminal of the surveillance
camera.
RJ45