HIKVISION DS-K1T673 - Video Intercom Settings

Note
If the peripheral card reader supports presenng EM card, the funcon is also supported to
enable/disable the EM card funcon.
Enable DESFire Card
The device can read the data from DESFire card when enabling the DESFire card funcon.
DESFire Card Read Content
Aer enable the DESFire card content reading funcon, the device can read the DESFire card
content.
Set Card
Authencaon Parameters
Set the card reading content when authencate via card on the device.
Go to
Conguraon → General → Card Authencaon Sengs .
Select a card authencaon mode and click Save.
Full Card No.
All card No. will be read.
Wiegand 26 (3 bytes)
The device will read card via Wiegand 26 protocol (read 3 bytes).
Wiegand 34 (4 bytes)
The device will read card via Wiegand 34 protocol (read 4 bytes).
8.5.20 Video Intercom
Sengs
Set Video Intercom Parameters
The device can be used as a door staon, outer door staon, or access control device. You should
set the device No. before usage.
Click Conguraon → Intercom → Device No. .
If set the device type as Door
Staon or Access Control Device, you can set the oor No., door
staon No., and click Advanced Sengs to set Phase No., Building No., and Unit No.
Click Save to save the
sengs aer the conguraon.
Device Type
The device can be used as a door staon or outer door staon. Select a device type from the
drop-down list.
DS-K1T673 Series Face Recognion Terminal User Manual
102