HIKVISION DS-K3G200X-R/M-Dm55 - Device Debugging; Component Status

Import and Export Parameters
Click Maintenance and Security → Maintenance → Backup and Reset .
Export
Click Export to export the device parameters.
Note
You can import the exported device parameters to another device.
Import
Click and select the le to import. Click Import to start import conguraon le.
6.6.14 Device Debugging
You can set device debugging parameters.
Steps
1.
Click Maintenance and Security → Maintenance → Device Debugging .
2.
You can set the following parameters.
Enable SSH
To raise network security, disable SSH service. The
conguraon is only used to debug the
device for the professionals.
Print Log
You can select a component from drop-down list and click Export to export log.
Capture Network Packet
You can set the Capture Packet
Duraon, Capture Packet Size, and click Start Capture to
capture.
6.6.15 Component Status
You can view the main lane and other status.
Main Lane Status
Device Component
You can view the status of the access control board, lane control board, user extended interface
board.
Peripheral
You can view the status of the RS-485 card reader.
DS-K3G200(L)X Series Tripod Turnsle
41