Full high turnstile • User Manual
7
position sensor, solenoid, damper,power supply.
IC/ID card access control, fingerprint, face recognition, code
reader, access control device send delay signal to the turnstile
board door signal（mach）
The control center of the system, when receiving the access
control device delay signal, it control solenoid open ,the
direction indicator light turns green, The rod of rotation can be
pushed to 90 degree or 120 degree ,the solenoid will lock
immediately when receiving closing signal from core position
sensor.
Display the current channel status
Detects and controls the opening and closing position of the
gate
Makes the shaft run smoothly
power supply to control board
System Operation Principle
1) Turn on the power, 2 seconds later; the system enters into work mode; the rod can’t be turn.
2) After swipe legal card or code and fingerprint, Access control device send opening signal to
control board.
3) The control board receives open signal, control indicator to green, solenoid open , The rod of
rotation can be pushed to 90 degree or 120 degree.
4) After the passenger push rod and then rotation turn to 90 or 120 degree , the position sensor
send close signal to control board, the solenoid lock immediately
5) Full turnstiles will lock after 5 seconds if the passenger swipe card but do not pass.
To Next Page
Loading...
