Full high turnstile • User Manual
19
rust with sand paper and spread with anti-rust oil if corroded;
3. Screws fastening: Check the connection of the various moving parts, fasten the screws where they
are loose to avoid causing fault for long-running;
4.Cleaning the bearings at the bottom of the shaft and add grease.
5. Circuit board cleaning: Cut off the power, and wipe dust of the board by using a clean brush;
6. Lines Checking: Check the connecting lines and solder reinforcement if they are loose off.
Note: This product is the strong professional technical equipment. In addition to daily maintenance,
please do not feel free to disassemble it. If a fault occurs while running, Please notify our service
departments or the authorized service agencies promptly to have it maintained. Do not disassemble
it at random to avoid damaging the internal structure or even damaging your interests because of
your improper operation.
To Next Page
Loading...
