HIKVISION DS-K3M200 User Manual

DS-K3M200 闸机门禁控制板如何接二维码读卡器
How to Connect QR Code Reader to DS-K3M200 Access Control Board
介绍:基于 Q340 和 JL700 的二维码读卡器，本文以闸机型号 DS-K3B801SX、DS-
K3B601SX、DS-K3B501SX 和 DS-K3Y501SX 的权限版 DS-K3M200 作为接入对象介绍 232
接线和配置。本文接线方法也适用于其他门禁控制板 232 接口接线。
Introduction: Based on Q340 and JL700 QR code reader, this article uses the turnstile model
DS-K3B801SX, DS-K3B601SX, DS-K3B501SX and DS-K3Y501SX authorized version DS-
K3M200 as the object to introduce 232 wiring and configuration. The wiring method in this
article is also applicable to the 232 interface wiring of other access control boards.
一、接线 wiring
第一种情况：如果二维码读卡器对外输出接口是 RJ45，这时我们需要做一根网线，插入 RJ45
头，另一个头线序通过查看该接口的管脚定义确定。
The first case: If the external output interface of the QR code reader is RJ45, then we need to
make a network cable, insert the RJ45 interface, and determine the line sequence of the other
said by checking the pin definition of the interface. As shown below:

HIKVISION DS-K3M200 Specifications

General

Brand	HIKVISION
Model	DS-K3M200
Category	IP Access Controllers
Language	English

Summary

Wiring Connections

RJ45 Interface Wiring

Connects QR code reader with RJ45 output to the access control board.

Separate Communication Line Wiring

Connects QR code reader with separate communication wires to the control board.

System Configuration

QR Code Reader Parameter Setup

Set baud rate to 115200 and 232 communication mode via QR code.

Access Control Board Configuration in IVMS-4200

Add K3M200 board to IVMS-4200 and verify serial port settings.

User Management and Issuing

Registering Personnel in IVMS-4200

Register personnel with their card numbers in the IVMS-4200 system.

Distributing Personnel to Access Control Board

Distribute registered personnel data to the DS-K3M200 access control board.

QR Code Authentication Verification

Monitoring Authentication Events

View QR code authentication records in the real-time event center.