HIKVISION DS-K5032-D

NTP
You should set the NTP server's IP address, port No., and interval.
Manual
By default, the device me should be synchronized manually. You can set the device me
manually or check Sync. with Computer Time to synchronize the device me with the
computer's me.
8.3.3 Set DST
Steps
1.
Click
Conguraon → System → System Sengs → DST .
Figure 8-3 DST Page
2.
Check Enable DST.
3.
Set the DST start me, end me and bias me.
4.
Click Save to save the sengs.
8.3.4 View Open Source
Soware License
Go to Conguraon → System → System Sengs → About , and click View Licenses to view the
device license.
8.3.5 Upgrade and Maintenance
Reboot device, restore device parameters, set logo and upgrade device version.
Reboot Device
Click
Conguraon → System → Maintenance → Upgrade & Maintenance .
DS-K5032 Series Visitor Terminal User Manual
59