HIKVISION DS-KB8113-IME1 Series - Page 55

Press  to Call
Steps
1.
Click Intercom → Press  to Call to enter the  page.
2.
Check Call Management Centeror Call  Indoor  to set the 
Note
If you check Call  Indoor , you should enter the  indoor  No.
3.
ClickBacklight Mode and you can select a backlight mode from the drop-down list.
I/O 
Steps
1.
Click Intercom → I/O  to enter the I/O input and output  page.
2.
Select I/O input No., input mode, output No., and output mode.
3.
Click Save to enable the 
Note
●
For door  there are 4 I/O input terminals. By default, Terminal 1 and 2 correspond to
Door Status. Terminal 3 and 4 correspond to interfaces of Door Switch.
●
For door  there are 2 I/O Output Terminals. Terminal 1 and 2 correspond to Door
interfaces (NO1/COM/NC1; NO2/COM/NC2) of door  Door 1 is enabled by default. You
can enable/disable IO Out according to needs.
Number 
Link the room No. and SIP numbers.
Click Intercom → Number  to enter the page.
DS-KB8113-IME1(B) Series Vandal-Resistant Door  User Manual
44