HIKVISION DS-KH6320-WTE1 User Manual

Steps
Note
Only when the Call Management Center funcon is enabled, should the call center
buon be displayed. For details, see the conguraon guide.
1.
Tap Call → to enter the residents calling page.
Figure 2-2 Call Resident
2. Enter the calling number.
The calling number format should be x-x-x-xxx. For example, the calling number of
Community 1, Building 2, Unit 3, and Room 405 is 1-2-3-405.
Note
The community No. can be omied.
3. Tap the call buon to start an audiovisual call.
4.
Oponal: Tap to call management center.
2.1.3 Call Indoor Extension/Indoor
Staon
If you install indoor staon and indoor extensions at home, you can call the indoor
extension via your indoor
staon, and vice versa.
Enter 【0-indoor extension No.】 on the indoor
staon to start calling.
Enter 【0-0】 to call the indoor staon from the indoor extension.
2.1.4 Receive Call
Network Indoor Staon Operaon Guide
3

HIKVISION DS-KH6320-WTE1 Specifications

General

Display Size	7 inch
Resolution	1024 × 600
Network Protocols	TCP/IP, SIP, RTSP
Audio Input	Built-in omnidirectional microphone
Audio Output	Built-in loudspeaker
Power Consumption	≤ 6 W
Operation Method	Touchscreen
Audio Compression Standard	G.711 U
Audio Compression Rate	64 Kbps
Wi-Fi Standard	IEEE802.11 b/g/n
Wi-Fi Frequency Range	2.4 GHz
RS-485	1
Working Temperature	-10 °C to 55 °C (14 °F to 131 °F)
Audio	Two-way audio
Power Supply	12 VDC, PoE (IEEE802.3af)
Installation	Wall-mounted
Display Type	TFT LCD
Network Interface	10/100 Mbps Ethernet
Alarm Output	1 channel
TF Card	up to 32 GB
Working Humidity	10% to 90%