HIKVISION DS-KV6113-PE1 User Manual

Video Intercom Villa Door Station User Manual
30
3. Click Draw Area. Click and drag the mouse on the live video to draw a motion detection area.
Click Stop Drawing to finish drawing one area. Click Save to save the settings.
Clear Area
Click Clear All to clear all of the areas.
Adjust Sensitivity
Move the slider to set the sensitivity of the detection.
4. Click Arming Schedule to edit the arming schedule.
5. Click on the time bar and drag the mouse to select the time period. Click Save to save the
settings.
Delete Schedule
Click Delete to delete the current arming schedule.
6. Click Linkage Method to enable the linkages.
Notify Security Center
Send an exception or alarm signal to the remote management software when an event
occurs.
7. Click Save to enable the settings.
Event Linkage
Steps
1. Click Event → Basic Event → Event Linkage to enter the settings page.

HIKVISION DS-KV6113-PE1 Specifications

General

Color	-
Wall mountable	Yes
Connectivity technology	Wired
Megapixel	2 MP
Supported video modes	720p, 1080p
Viewing angle, vertical	75 °
Maximum video resolution	1920 x 1080 pixels
Viewing angle, horizontal	129 °
Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet interface type	Fast Ethernet
Supported network protocols	TCP/IP, RTSP
Product color	Black, Grey
International Protection (IP) code	IP65
LED type	IR
Indoor unit included	No
Outdoor unit power type	DC
Power consumption (typical)	10 W
Operating temperature (T-T)	-40 - 55 °C
Operating relative humidity (H-H)	10 - 95 %
Display diagonal	- \
Operating system installed	Embedded LINUX

Weight and Dimensions

Depth	65 mm
Width	138 mm
Height	27 mm