HIKVISION DS-PHA64-M User Manual

Note
By default, the vericaon code is printed on the device label.
6. Tap Wireless
Connecon on the Select Connecon Type page.
7. Follow the
instrucons on the Turn on Hotspot page and change the control panel to the AP
mode. Tap Next.
Note
You need to remove the rear panel of the device and the AP/STA switch is on the back of the
device.
8. Select a stable Wi-Fi for the device to connect and tap Next.
Note
Make sure the device and the mobile phone are connect to the same Wi-Fi.
9. Follow the instrucons. Create the device password and tap Acve.
Note
We highly recommend you to create a strong password of your own choosing (using a minimum
of 8 characters, including at least three kinds of following categories: upper case leers, lower
case leers, numbers, and special characters) in order to increase the security of your product.
And we recommend you reset your password regularly, especially in the high security system,
reseng the password monthly or weekly can beer protect your product.
10. Follow the instrucons on the Turn on Hotspot page and change the control panel to the STA
mode. Tap
Conrm.
Note
You need to remove the rear panel of the device and the AP/STA switch is on the back of the
device.
11. Aer the connecon is nished, enter the device alias and tap Save.
12.
Oponal: You can delete the device.
1)On the device list page, tap the security control panel and then log in to the device (if
required) to enter the area page.
2)Tap
→ Delete Device to delete the device.
4.3.3 Add Control Panel to the Mobile Client
Add a control panel to the mobile client before other
operaons.
Before You Start
• The control panel has been
acvated.
• The control panel has registered to Hik-Connect. For details, see Mobile Client Registraon .
Hybrid Security Control Panel User Manual
64

HIKVISION DS-PHA64-M Specifications

General

Brand	HIKVISION
Model	DS-PHA64-M
Category	Control Panel
Language	English