You can tap the target user on the user list and then tap to set
the permissions authorized to the target user.
Note
Only the administrator can do such an operation.
If the target user is an operator, tap the target user on the user list
and then tap Linked Areas to set the area linked to the target user.
Note
Only the administrator can do such an operation.
If the target user is an administrator, an installer or an operator, you
can tap the target user on the user list and then tap Change Keypad
Password to set the keypad password to the target user.
Note
The password (PIN code) is allowed to be 4 to 6 digits. No number is
disallowed, with 10,000 to 100,000 differs, and no limit of the digit
combination.
After you add one keypad, you can add PIN code (Keypad Password)
in the user menu. When you click in the input box, there will be
indication shows that 4 to 6 numbers allowed. This is the same for
each user
If the target user is an administrator or an operator, you can tap the
target user on the user list and then tap Change Duress Password to
set the duress password to the target user.
Note
If under duress, you can enter the duress code on the keyboard to
arm and disarm area(s) and upload a duress alarm.
An administrator, an installer or an operator can control the relay
module, wall switch and smart plug.
Note
● Configuration items and user permission will vary according to the user type.
To Next Page
Loading...
Need help?
General
