ECI-T24Fx Quick Start Guide
QSG ECI-T24Fx 041018NA 10
3 Network Camera LAN Configuration
Note:
The use of products with internet access carries inherent security risks. In order to avoid
network attacks and information leakage, strengthen your own network protection.
If the product does not work properly, contact your dealer or the nearest service center for
help.
3.1 Wiring
Connect the camera to the network as follows:
Network Cable
or
Network Camera
Computer
Connect Directly
Figure 3-1
N
e
t
w
o
r
k
C
a
b
l
e
N
e
t
w
o
r
k
C
a
b
l
e
or
or
Network Camera
Computer
Connect via a Switch or a Router
Figure 3-2
3.2 Activate the Camera
Activate the camera by setting a strong password. Activation via web browser, activation via
SADP, and activation via client software are supported. Activation via SADP software and
web browser will be used as examples to introduce camera activation.
Note:
Refer to the Network Camera User Manual for activation via client software.
3.3 Activation via Web Browser
Steps:
1. Power the camera on. Connect the camera to your computer or the switch/router that
your computer connects to.
2. Input the IP address into the address bar of the Web browser, and press Enter to enter
the activation interface.
Notes:
The camera’s default IP address is 192.168.1.64.
The computer and the camera should belong to the same subnet.
For cameras that have DHCP enabled by default, use the SADP software to search for the
IP address.
To Next Page
Loading...
Need help?
General
