Installation Manual of Network Dome Camera
3
Notice:
1. Make sure the power supply voltage is correct before using the camera.
2. Do not drop the camera or subject it to physical shock.
3. Do not touch sensor modules with fingers. If cleaning is necessary, use a clean cloth with
a bit of ethanol and wipe it gently. If the camera will not be used for an extended period
of time, put on the lens cap to protect the sensor from dirt.
4. Do not aim the camera at the sun or extra bright places. A blooming or smear may occur
otherwise (which is not a malfunction however), and affecting the endurance of sensor at
the same time.
5. The sensor may be burned out by a laser beam, so when any laser equipment is being
used, make sure that the surface of the sensor will not be exposed to the laser beam.
6. Do not place the camera in extremely hot or cold temperatures (the operating
temperature should be between -10°C ~ +60°C, dusty or damp locations, and do not
expose it to high electromagnetic radiation.
7. To avoid heat accumulation, good ventilation is required for a proper operating
environment.
8. While shipping, the camera should be packed in its original packing, or packing of the
same texture.
9. Regular part replacement: a few parts (e.g. electrolytic capacitor) of the equipment
should be replaced regularly according to their average life time. The average time varies
because of differences between operating environment and usage history, so regular
Hangzhou Hikvision Digital Technology Co., Ltd. | Copyright ©
To Next Page
Loading...
Need help?
General
