Need help?Do you have a question about the HIKVISION Network Speed Dome and is the answer not in the manual?
General| IK code | IK10 |
|---|---|
| Form factor | Dome |
| Mounting type | Ceiling |
| Product color | Black, White |
| International Protection (IP) code | IP67 |
| Total megapixels | 2 MP |
| Maximum resolution | 1920 x 1080 pixels |
| Supported video modes | 1080p |
| Automatic gain control | Yes |
| Video compression formats | H.264, H.264+, H.265, H.265+, M-JPEG |
| Analog signal format system | NTSC, PAL |
| Supported graphics resolutions | 352 x 240, 352 x 288, 640 x 480 (VGA), 704 x 480, 704 x 576, 1280 x 720 (HD 720), 1280 x 960, 1920 x 1080 (HD 1080) |
| Sensor type | CMOS |
| Number of sensors | 1 |
| Optical sensor size | 1/1.8 \ |
| Pan range | 0 - 360 ° |
| Pan speed | 210 °/sec |
| White balance | ATW, Auto, Fluorescent, Indoor, Lamp, Manual, Outdoor |
| Pan preset speed | 280 °/sec |
| Tilt angle range | -20 - 90 ° |
| Tilt preset speed | 250 °/sec |
| Camera shutter speed | 1/1 - 1/30000 s |
| Minimum illumination | 0 lx |
| Preset programs quantity | 300 |
| Focus | Motorized/Manual |
| Digital zoom | 16 x |
| Optical zoom | 36 x |
| Focal length range | - mm |
| Detect distance (tele) | 1.5 m |
| Detect distance (wide) | 0.01 m |
| Maximum aperture number | 4.5 |
| Minimum aperture number | 1.5 |
| Type | IP security camera |
| PTZ modes | 4 Pattern, Auto Scan |
| PTZ protocols | Pelco-P/D |
| Placement supported | Indoor & outdoor |
| Connectivity technology | Wired |
| Behavior analysis | Intrusion detection, Line crossing detection |
| LED type | IR |
| Night vision distance | 200 m |
| Voice codecs | G.711alaw, G.711ulaw, G.722.1, G.726, MP2L2 |
| Audio input channels | 1 channels |
| Audio formats supported | PCM |
| Wi-Fi | No |
| Number of users | 32 user(s) |
| Cabling technology | 10/100Base-T(X) |
| Networking standards | IEEE 802.1x |
| Ethernet interface type | Fast Ethernet |
| Supported network protocols | IPv4/IPv6, HTTP, HTTPS, 802.1x, Qos, FTP, SMTP, UPnP, SNMP, DNS, DDNS, NTP, RTSP, RTCP, RTP, TCP/IP, DHCP, PPPoE, Bonjour |
| Number of simultaneous users | 20 user(s) |
| Compatible memory cards | MicroSD (TransFlash), MicroSDHC |
| Maximum memory card size | 256 GB |
| AC input voltage | 24 V |
| Power source type | AC, PoE |
| Power consumption (max) | 60 W |
| Power consumption (Power over Ethernet (PoE)) | 50 W |
| Operating temperature (T-T) | -40 - 70 °C |
| Operating relative humidity (H-H) | 0 - 90 % |
Weight and Dimensions| Height | 410 mm |
|---|---|
| Weight | 8000 g |
| Diameter | 266.6 mm |
Critical safety guidelines to prevent injury, death, or equipment damage.
Guides on connecting and configuring the speed dome within a Local Area Network.
Instructions for connecting and configuring the speed dome over a Wide Area Network.
Step-by-step guide for accessing the speed dome using a web browser.
Instructions for using the provided client software to manage the speed dome.
Covers controlling the pan, tilt, zoom, and preset functions of the speed dome.
Steps to set or reset the default or custom initial position of the PTZ.
Configuration of core PTZ functions like proportional pan, preset speed, and OSD.
Setting the physical boundaries for the PTZ movement.
Programming the speed dome to perform actions automatically at specific times.
Network configuration including TCP/IP, ports, DDNS, and other network services.
Adjusting video stream parameters, audio encoding, and sampling rates.
Configuring display parameters, OSD, text overlays, and image enhancements.
Setting up motion detection, video loss, tampering, and other alarm events.
Setting up schedules for continuous or event-triggered video recording.
Procedures for rebooting, restoring defaults, importing/exporting config, and upgrading.
To Next Page