Configuration> Advanced Configuration> Security > Authentication
Figure 10-4 RTSP Authentication
2. Set the authentication mode for each authentication type.
RTSP Authentication: Select the authentication mode as basic or disable in
the dropdown list to enable or disable the RTSP authentication.
WEB Authentication: Select the authentication mode as basic or digest in
the dropdown list.
3. Click to save the settings.
10.3 Configuring Anonymous Visit
When you enable this function, you can log into the camera without a username and
password.
In login interface, check the Anonymous checkbox and click Login to enter the
camera as shown in Figure 10-6.
Figure 10-5 Anonymous Login
Figure 10-6 Login Interface
10.4 Configuring IP Address Filter
With this function on, the camera allows certain IP addresses whether to log in or
not.
To Next Page
Loading...
