1. Check the checkboxes of desired functions, including Target Tracking, Face
Tracking and License Plate Tracking.
Target Tracking: When a smart event is detected, e.g. line crossing
detection, the object which trigger the pre-defined rule will be
automatically tracked, and the image quality of the tracking target will be
increased.
Face Tracking: When the face detection is triggered, the image quality of
the face will be increased.
• To enable target tracking function, at least one smart event should be
enabled.
• To enable face tracking function, the face detection function should be
supported and enabled.
2. Respectively set the ROI level. The higher the value, the better image quality in
the red frame.
3. Click Save to save the settings.
6.5 Configuring Image Settings
6.5.1 Configuring Display Settings
Purpose:
You can set the image quality of the speed dome, including brightness, contrast,
saturation, sharpness, etc.
The parameters in Display Settings interface vary depending on the models of
speed dome.
You can double click the live view to enter full screen mode and double click it
again to exit.
Steps:
1. Enter the Display Settings interface:
Configuration > Basic Configuration> Image> Display Settings
Or Configuration > Advanced Configuration> Image> Display Settings
2. You can select the Mounting Scenario in the dropdown list with different
predefined image parameters.
3. Set the image parameters of the speed dome.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
