Figure 6-54 Alarm Output Settings
6. You can copy the settings to other alarm outputs.
7. Click to save the settings.
6.6.6 Handling Exception
The exception type can be HDD full, HDD error, network disconnected, IP address
conflicted and illegal login to the speed domes.
Steps:
1. Enter the Exception Settings interface:
Configuration > Advanced Configuration> Events > Exception
2. Check the checkbox to set the actions taken for the Exception alarm. Refer to
Step 3 in Section 6.6.1 Configuring Motion Detection.
Figure 6-55 Exception Settings
3. Click to save the settings.
To Next Page
Loading...
