Wiegand Camera ·Operation Manual
8
The update frequency, update time, file name, etc. can be set. The
corresponding URL protocol are listed as follows.
When configuring the FTP parameters of the Blacklist & Whitelist via URL, the Blacklist
& Whitelist is off by default.
You can tell whether the configuration succeeds or not by checking the Last
Update and Upload Info.
http://10.5.148.102/ISAPI/System/Network/ftpUploadTimeUrl?enable=1&cycle=1&cust
omDay=2&hour=0&name=test.xls
Key Parameters Description:
10.5.148.102: replace it for the IP address of the device
enable: enable the update for Blacklist &Whitelist. 0 stands for Close, 1
stands for Enable. The default status is 1.
cycle: 1 stands for daily update; 2 stands for weekly update; 3 stands for
customized update. The default cycle is 1.
customDay: when you set cycle as 3(customized), customDay represents
time interval (day). The default day is 1.
hour: it is the time to update. Only integral hour and the 24-hour system
are supported. The default time is 0.
name: it is the file name for Blacklist & Whitelist. The full name should be
kept, including .xls. Only English name and path are supported.
To Next Page
Loading...
