Hill-Rom P1440B - Chapter 4: Removal, Replacement, and Adjustment Procedures

4
Hill-Rom® Basic Care™ Bed, Hill-Rom® 305 Manual Bed, Page 4 - 1
Hill-Rom® 405 Electric Bed Service Manual (MAN336 REV 2)
Chapter 4
Removal, Replacement, and
Adjustment Procedures
Tool and Supply Requirements
To service the bed, the tools and supplies that follow as applicable:
• Phillips head screwdriver
• Screwdriver
• Small screwdriver
• 13 mm socket
• 17 mm socket
• Ratchet
• 8 mm nut driver, deep well
• 13 mm nut driver
•6 mm wrench
•8 mm wrench
• 17 mm wrench
• 2.5 mm hex wrench
• 3 mm hex wrench
• 4 mm hex wrench
• 4 mm T-handle hex wrench
• 5 mm hex wrench
• 8 mm hex wrench
• 10 mm hex wrench
• 13mm hex wrench
• Wire cutters
• Needle nose pliers
• Rubber mallet