12 English
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: Maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise emission values
Sound power level (L
WA
)
117 dB(A)
Uncertainty for the sound power level (K
WA
)
3 dB(A)
Emission sound pressure level (L
pA
)
106 dB(A)
Uncertainty for the sound power level (K
WA
)
3 dB(A)
Total vibration
Vibration emission value (a
h
)
5.1 m/s²
Uncertainty (K)
1.5 m/s²
4.3 Selecting suitable cutting discs
▶ Use only cutting discs with a specification suitable for the intended application.
Cutting disc specifications
Area of application Cutting disc specifications
Cutting mineral materials Diamond cutting discs as per EN 13226
Cutting metal Synthetic resin-bonded, fiber-reinforced cutting discs in
accordance with EN 12413 (flat, type 41)
1)
1)
To allow the disc to be fitted to the tool, the special DCH 300 ABR mounting flange (accessory) must be used.
▶ Observe the disc mounting instructions issued by the disc manufacturer.
4.4 Dimensions and format of suitable diamond cutting discs
Diamond cutting discs must meet the following require-
ments in terms of dimensions and format.
Technical data
Slot width between segments
(G)
≤ 10 mm
Cutting angle Negative
5 Operation
5.1 General information
5.1.1 Using a generator or transformer
This tool may be powered by a generator or transformer when the following conditions are fulfilled:
• The power output of the generator or transformer (in watts) must be at least twice the power rating of the
tool (see type identification plate).
• The voltage provided by the power source must remain within +5 % and –15 % of the tool’s rated
voltage.
• Frequency: 50 to 60 Hz (never above 65 Hz)
• The power source must be equipped with automatic voltage regulation and starting boost.
ATTENTION
Risk of damage Switching on or switching off other power tools or appliances connected to the generator
or transformer may cause undervoltage and/or overvoltage peaks, resulting in damage to the cutter.
▶ Never operate other power tools or appliances from the generator or transformer at the same time. Where
applicable, use a generator or transformer designed for simultaneous operation of the cutter and vacuum
cleaner.
Printed: 02.02.2018 | Doc-Nr: PUB / 5398464 / 000 / 00
To Next Page
Loading...
Need help?
General
