What causes water to escape at the water swivel or gear housing of my Hilti Drill?
Water escaping from the water swivel or gear housing of your Hilti Drill can be due to two reasons. The water pressure might be too high, in which case you should reduce it. Alternatively, the rotary shaft seal could be worn out and needs replacement.
What to do if my Hilti DD 160 diamond core drilling machine does not start?
If your Hilti diamond core drilling machine isn't starting, there could be several reasons: * Check for an interruption in the electrical supply by testing another tool in the same outlet. * Inspect the supply cord, extension cord, supply cord plug, and PRCD, replacing them if necessary. * If there is water in the motor, allow the tool to dry completely in a warm, dry place. * If these steps don't work, the on/off switch is defective or there is a fault in the electronics. In this case, have the machine repaired by Hilti Service.
What does it mean if the service indicator shows on my Hilti Power Tool?
If the service indicator is illuminated on your Hilti diamond core drilling machine, it means the carbon brush wear limit has almost been reached. The machine will continue to run for a few hours until it shuts down automatically. Have the carbon brushes replaced at the next opportunity.
What to do if my Hilti DD 160 Power Tool diamond core drilling machine does not start and service indicator lights up?
If your Hilti diamond core drilling machine doesn't start and the service indicator is lit, the carbon brushes are likely worn out. Replace the carbon brushes.
What to do if my Hilti Power Tool diamond core drilling machine does not start and service indicator flashes?
If your Hilti diamond core drilling machine doesn't start and the service indicator flashes, it could be due to two reasons: * The motor has overheated. Wait a few minutes until the motor has cooled down or allow the machine to run under no load to speed up cooling. Then, switch the machine off and on again. * There is an overload error. Switch the machine off and on again.
What to do if my Hilti Power Tool diamond core drilling machine does not start and theft protection indicator flashes?
General| Power | 2200 W |
|---|---|
| Speed 1 | 510 rpm |
| Water supply connection | Yes |
| Rated Voltage | 230 V |
| Rated Current | 10 A |
| Rated Input | 2200 W |
| Voltage | 230 V |
| Chuck Type | BI+ |
Essential safety warnings applicable to all power tools.
Guidelines for safe work environment and electrical connections.
Safety precautions specific to diamond core drilling operations.
Approval, structural integrity, and hazard avoidance in the workplace.
Safety measures for power supply, cords, and machine condition.
Steps for mounting the drilling machine onto the drill stand.
Procedures for securing the drill stand using vacuum or anchor base plates.
Operating procedures for drilling with and without a vacuum extractor.
A guide to identifying and resolving common operational issues.
To Next Page
