16 17
2. Safety information
CAUTION
Take care to avoid incorrect
measurements caused by using a
defective product or a product which
has been dropped or subjected to any
other inadmissible stresses or
changes.
Preventative measures
Carry out measurements periodically to check
the accuracy of the product, particularly after it
has been exposed to excessive stresses and
before and after important measuring tasks.
WARNING
Failure to adequately cordon off the
area in which you are measuring may
lead to dangerous situations in road
traffic, on building sites or in industrial
plants, etc.
Preventative measures
Always ensure that the area in which you are
carrying out measuring work is properly
cordoned off. Observe the statutory accident
prevention regulations and road traffic
regulations of the applicable country.
CAUTION
Taking measurements from surfaces
with low reflectance surrounded by
areas with high reflectance may lead
to measurement errors.
Preventative measures
Take measurements from the brown side of the
Hilti target plate at distances above 40 m.
CAUTION
Rapidly changing conditions such as
large changes in distance while in
tracking mode or rapidly moving
target objects may lead to
measurement errors.
Operating risks, continued
continued
2. Safety information
Responsibility of the owner
WARNING
The owner is responsible for the
correct use of the equipment, the use
of the equipment by his employees,
their instruction and the operating
safety of the equipment.
The owner has the following obligations:
• To ensure that he has understood the safety
information on the product and the
information contained in the operating
instructions.
• To be aware of the locally applicable
industrial accident prevention regulations.
• To notify Hilti immediately of any safety-
related defects or deficiencies in the
equipment.
Operating risks
WARNING
Use of the product without instruction
or with incomplete instruction may
lead to errors by the operator or
misuse and thus to accidents resulting
in serious personal injury, pecuniary
damage or damage to property and
the environment.
Preventative measures
All users must observe the safety information
issued by the manufacturer and the owner’s
instructions.
CAUTION
Care must be taken to avoid incorrect
measurements.
Preventative measures
Keep the receiving lens clean. It should be
cleaned at regular intervals. See section 5,
“Cleaning and drying”.
Division of responsibilities, continued
continued
To Next Page
Loading...
