English 3
Item reference numbers are used in the overview illustrations and refer to the numbers used in
the product overview section
This symbol is intended to draw special attention to certain points when handling the product.
Wireless data transfer
1.3 Labels on the PLT 300
The following labels are applied to the PLT 300:
Laser radiation. Do not stare into the beam. Class 2 laser.
1.4 Product information
Hilti products are designed for professional use and may be operated, serviced and maintained only by
trained, authorized personnel. This personnel must be informed of any particular hazards that may be
encountered. The product and its ancillary equipment can present hazards if used incorrectly by untrained
personnel or if used not in accordance with the intended use.
The type designation and serial number are stated on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Type: PLT 300
Generation: 01
Serial no.:
1.5 Declaration of conformity
We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration of conformity can be found at the end of this documentation.
The technical documentation is filed here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | D-86916 Kaufering, Germany
2 Safety
2.1 Safety instructions
2.1.1 Basic information concerning safety
In addition to the safety rules listed in the individual sections of these operating instructions, the
following rules must be strictly observed at all times. The PLT 300 and its ancillary equipment may
present hazards when used incorrectly by untrained personnel or when used not as directed.
▶ Never use the PLT 300 and PLC 300 without having received the appropriate instruction on their
use or without having read these operating instructions.
▶ Always observe the operating instructions and warnings given in the applications displayed.
▶ Do not render safety devices ineffective and do not remove information and warning notices.
▶ Modification of the PLT 300 and PLC 300 or tampering with their parts is not permissible.
▶ To reduce the risk of injury, use only genuine Hilti accessories and ancillary equipment.
▶ Never point the PLT 300 or its accessories toward yourself or other persons.
Printed: 31.01.2018 | Doc-Nr: PUB / 5245389 / 000 / 01
To Next Page
Loading...
Need help?
General
