Hilti PMC 36 User Manual

2.5 Information displayed during operation
LED
The LED doesn’t light.
The tool is switched off.
The LED doesn’t light.
The batteries are exhausted.
The LED doesn’t light.
The batteries are inserted incorrectly.
The LED lights con-
stantly.
The laser beam is switched on. The tool is in
operation.
The LED blinks. The batteries are almost exhausted.
The LED blinks.
The temperature of the tool is greater than 50°C
(122°F) or less than -10°C (14°F) (the laser beam
does not light).
Laser beam The laser beam blinks
twice every 10 seconds.
The batteries are almost exhausted.
The laser beam blinks
rapidly.
The tool cannot level itself (outside the 3.5°
self-leveling range).
The laser beam blinks
slowly.
Movement of the pendulum is blocked. The foot of
the tool is in the closed position.
3. Accessories
Tripod PA 910
Tripod PA 911
Tripod PA 921
Tripod PA 931/2
Target plate PMA 50/51
Target plate PRA 50/51
Laser receiver PMA 30
Pipe adapter PMA 70
Wall mount PMA 71
Drywall adapter PMA 75
Magnetic bracket PMA 74
Telescopic brace PUA 10
Frame clamp PMA 25
Ceiling clamp
PMA 76
Hilti toolbox
PMC 36
Laser visibility glasses PUA 60 The laser visibility glasses are not
protective glasses and thus do not
protect the eyes from laser beams.
As the laser visibility glasses
restrict color vision, they should
be worn only when working with
this tool and must not be worn
while driving a vehicle on a public
road.
en
16

Hilti PMC 36 Specifications

General

Brand	Hilti
Model	PMC 36
Category	Laser Level
Language	English