How to fix Hilti PR 30-HVS A12 tool if it doesn't work?
If your Hilti Measuring Instruments tool isn't working, ensure the battery is fully inserted until you hear an audible click. Also, check if the battery is low and replace or charge it if necessary.
What to do if Hilti PR 30-HVS A12 Measuring Instruments battery doesn’t engage with an audible click?
If the battery doesn’t engage with an audible click on your Hilti Measuring Instruments, clean the retaining lugs on the battery and refit the battery.
What to do if Hilti Measuring Instruments rotating laser has low battery?
If the rotating laser has a low battery, charge the battery of your Hilti Measuring Instruments.
What to do if Hilti PR 30-HVS A12 Measuring Instruments tool or battery gets very hot?
If the Hilti Measuring Instruments tool or battery gets very hot, immediately switch off the tool, remove the battery, keep it under observation, allow it to cool down and contact Hilti Service due to a possible electrical fault.
Why does Hilti PR 30-HVS A12 Measuring Instruments battery run down quickly?
If the battery of your Hilti Measuring Instruments runs down more quickly than usual, it might be due to a very low ambient temperature. Warm up the battery slowly to room temperature.
What to do if Hilti PR 30-HVS A12 command is not possible?
If the command is not possible and there is no reaction from your Hilti Measuring Instruments, check that all devices are switched on and within direct range. Then, repeat the entry.
General| Type | Rotating Laser |
|---|---|
| Accuracy | ±0.5 mm at 10 m |
| Self-leveling Range | ±5° |
| Laser Class | Class 2 |
| Laser Class Details | IEC 60825-1:2014 |
| Protection Class | IP66 |
| Battery Voltage | 12 V |
| Battery Type | Li-ion |
| Power Supply | Li-ion battery |
| Rotation Speed | 600 rpm |
| Operating Temperature | -20 to +50 °C |
To Next Page
