Hilti SF 6-A22 Instructions

*2231426*
2231426 English 23
Trouble or fault Possible cause Action to be taken
1 LED flashes.
The drill / driver does not
work.
The battery is discharged. ▶ Change the battery and charge
the empty battery.
The battery is too cold. ▶ Bring the battery to the recom-
mended working temperature.
The battery is too hot. ▶ Bring the battery to the recom-
mended working temperature.
SF 6H-A22
Hammer-action drilling is not
possible.
The operating mode is not set cor-
rectly at the selector ring.
▶ Set the selector ring to the
“Hammer-action drilling” posi-
tion .
The control switch cannot be
pressed, or is stuck.
The forward/reverse selector
switch is in the middle position
(transport position).
▶ Set the forward/reverse selector
switch to forward or reverse ro-
tation, as applicable. → page 21
The drill / driver or the battery
gets very hot.
Electrical fault ▶ Switch the drill / driver off
immediately, remove the battery
and contact Hilti Service.
The drill / driver is overloaded (ap-
plication limit exceeded).
▶ Check the application.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10 RoHS (Restriction of Hazardous Substances)
Click on the links to go to the table of hazardous substances:
• SF 6-A22: qr.hilti.com/r9370541
• SF 6H-A22: qr.hilti.com/r9370482
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
11 Manufacturer’s warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Printed: 19.08.2019 | Doc-Nr: PUB / 5467412 / 000 / 01

Hilti SF 6-A22 Specifications

General

Tool type	Cordless Drill Driver
Battery voltage	21.6 V
Chuck capacity	1.5 - 13 mm
Number of gears	2
Battery Type	Li-ion
Chuck type	Keyless chuck