English 11
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Remove the O-ring from the groove in the socket.
3. Place the socket on the square drive spindle of the tool.
4. Pull out the locking pin.
5. Place the socket on the square drive spindle of the tool.
Take care to ensure that the holes in the square drive spindle and socket, into which the locking
ring fits, are in alignment with each other.
6. Insert the locking pin in the socket.
7. Fit the O-ring on the socket.
5.5 Removing the socket
SIW 22T-A
1
/
2
"
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Pull the accessory tool off the square drive.
5.6 Removing the socket
SIW 22T-A
3
/
4
"
Printed: 05.04.2018 | Doc-Nr: PUB / 5136064 / 000 / 05
To Next Page
Loading...
