Hilti TE 2000-AVR User Manual

10 English
5.1.2 Fitting the accessory tool
1. Unplug the supply cord from the power outlet.
2. Lightly grease the connection end of the accessory tool.
➥
Use only the recommended grease supplied by Hilti. Using the wrong grease can result in damage
to the tool.
3. Push the accessory tool into the chuck as far as it will go, turning it and applying light pressure until it
engages with an audible click.
4. Check that the chisel has engaged correctly by gripping and pulling it.
5.1.3 Removing the accessory tool
CAUTION
Risk of injury! The accessory tool may be hot and/or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
▶ Never lay down a hot accessory tool on a flammable surface.
1. Unplug the supply cord from the power outlet.
2. Pull the accessory tool retaining bar back as far as it will go.
3. Remove the accessory tool.
5.2 Types of work
WARNING
Risk of electric shock! Severe injury and burns can result if any attempt is made to operate the tool without
an earth/ground conductor and ground fault circuit interrupter correctly connected.
▶ Irrespective of whether mains power or generator power is used, always make sure that an earth/ground
conductor and ground fault circuit interrupter are present in the power supply and that these are correctly
connected.
▶ Do not use the product unless these safety measures are in place and fully operational.
Printed: 20.05.2019 | Doc-Nr: PUB / 5333035 / 000 / 04

Hilti TE 2000-AVR Specifications

General

Input power	2100 W
Power source	AC
Power plug type	Type C
Impact energy (max)	32 J
Idle impact rate (max)	1800 IPM
Vibration level (chiseling)	4.8 m/s²
Toolholder	- mm
Product color	Black, Red
Country of origin	Germany
Quantity per shipping (inner) case	1 pc(s)

Weight and Dimensions

Depth	731 mm
Width	574 mm
Height	146 mm
Weight	14500 g
Package depth	100 mm
Package width	150 mm
Package height	76 mm
Package weight	500 g